NSX-T V6-3.2L DOHC (VTEC) (1997)
-
Stop drying the filler if a white mark appears when the surface is scratched with your nail. Wet or dry sand the surface flat and smooth with a
#280 or # 320 paper.
6. Air Blowing/Degreasing
Air blow the surface to be repaired, then degrease with a wax and grease remover (for USA usage-DuPont 38125 Enamel Reducer).
NOTE: Also clean and degrease the surfaces where masking tape will be attached.
7. Masking
Mask the areas surrounding the damage to prevent overspray from the primer surfacer.
NOTE: Use masking tape and paper to cover the undamaged areas.
8. Application of Undercoating (Primer Surfacer)/ Drying
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in a safe place, and keep it away from sparks, flames or cigarettes.
-
Spray the primer surfacer over the filler and surface (use epoxy or urethane 2-part primer surfacer).
Spray : 2-3 coats.
-
Use the following materials:
615S Primer Surfacer (DuPont)
Primer Surfacer EP (Akzo)
NPS735 Urethane Primer Surfacer (R-M)
-
Let the primer surfacer air dry for 5-10 minutes, then force dry with a infrared lamp.
NOTE: Keep the dryer 40-50 cm (16-20 in) from the surface.
9. Application of Polishing Undercoat
-
Remove the masking paper and tape.
-
Check that the undercoat is dried thoroughly, then dry or wet sand the surface with a #280 or #320 paper.
NOTE:
-
Use a rubber block and sand flat and smooth.
-
Sand the entire surface to be refinished.
10. Air Blowing/Degreasing
WARNING:
-
Do not use high air pressure: use only an approved, 210 kPa (2.1 kg/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
Air blow all the surfaces, then degrease with a wax and grease remover (for USA usage-DuPont 38125 Enamel Reducer).
NOTE: Also degrease the surfaces where masking tape will be attached.
11. Masking
Mask the undamaged areas surrounding the damage to prevent overspraying of primer surfacer (intermediate coat).
NOTE: Use masking tape and paper to mask the body. A vinyl cover may also be used to effectively mask the body.
12. Application of Intermediate Coat 1 (Primer surfacer-is used for this purpose) spraying/drying
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before opening
paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in a safe place, and keep it away from sparks, flames or cigarettes.
-
Spray either 2-part epoxy or urethane primer surfacer to polished primed surface as intermediate coat.