NSX V6-3.2L DOHC (2001)
Air Bag: Service and Repair
Passenger Side
REMOVAL
WARNING: Store a removed airbag assembly with the pad surface up; if the airbag is improperly stored face down, accidental deployment
could propel the unit with enough force to cause serious injury.
CAUTION
- Do not install used SRS parts from another car. When repairing, use only new SRS parts.
- Carefully inspect the airbag assembly before you install it. Do not install an airbag assembly that shows signs of being dropped or improperly handled,
such as dents, cracks or deformation.
- Do not disassemble or tamper with the airbag assembly.
1. Before disconnecting any parts of the SRS wire harness, install the short connectors (RED).
Passenger's Airbag
Passenger's Airbag
2. Remove the glove box, then remove the four mounting nuts from the bracket.
3. Remove the bracket and mounting nut from the passenger's airbag assembly.
4. Carefully lift the passenger's airbag assembly out of the dashboard.
INSTALLATION
CAUTION
- Be sure to install the SRS wiring so that it is not pinched or interfering with other car parts.
- Be sure the battery cables are disconnected.
- After completing repair work, be sure to remove the short connectors (RED) and reconnect all the connectors.
1. Place the passenger's airbag assembly in the dashboard.
2. Press the airbag assembly downwards, and turn the adjusting nut until it touches the lower part of the airbag assembly. Then, turn it back half a
turn so that there is a small gap between adjusting nut and the airbag assembly.
3. Install the bracket and mounting nuts.
