NSX V6-3.2L DOHC (2001)
Air Bag: Service and Repair
Driver Side
Driver's Airbag Replacement
REMOVAL
WARNING: Store a removed airbag assembly with the pad surface up; if the airbag is improperly stored face down, accidental deployment
could propel the unit with enough force to cause serious injury.
CAUTION
- Do not install used SRS parts from another car. When repairing, use only new SRS parts.
- Carefully inspect the airbag assembly before you install it. Do not install an airbag assembly that shows signs of being dropped or improperly handled,
such as dents, cracks or deformation.
- Do not disassemble or tamper with the airbag assembly.
1. Before disconnecting any parts of the SRS wire harness, install the short connectors (RED).
Driver's Airbag
2. Remove the two Torx bolts using a Torx T30 bit, then remove the driver's airbag assembly.
INSTALLATION
CAUTION
- Be sure to install the SRS wiring so that it is not pinched or interfering with other car parts.
- Be sure the battery cables are disconnected.
- After completing repair work, be sure to remove the short connectors (RED) and reconnect all the connectors.
