RDX L4-2.3L Turbo (2008)
5. Install the trim in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones,
-
Push the clips and hooks into place securely.
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
Rear Door Sill Area
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Tip the front of the rear seat up.
2. Detach the hook (A) and tab (B) from the B-pillar lower trim (C), and pull the rear door sill trim (D) up by hand to detach the clips (E, F), then
remove it.
3. If necessary, pull the rear side outer trim (G) up to detach the clips (H), then remove the trim.
4. Pull out the rear door opening seal (A) from the trim hooks (B) and around the front door opening flange, then remove the seal.