RDX L4-2.3L Turbo (2008)
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Remove these items:
-
Front door sill trim
-
Rear door sill trim
-
Front door opening seal, as needed
-
Rear door opening seal, as needed
-
Remove the lower anchor bolt
2. Slide the front seat forward fully.
3. Remove the B-pillar lower trim (A).
1. Pull the upper portion of the trim back to release the upper hooks (B).
2. Detach the lower clips by pulling the bottom of the trim back by hand.
4. Pull the bottom of the B-pillar upper trim (A) back by hand to detach the lower hooks (B). Release the upper pin (C) by pulling the top of the
B-pillar upper trim.
5. Pull the trim down to release the upper hooks (D).
