RDX L4-2.3L Turbo (2008)
10. Carefully reinstall the grommet (A) on the pin (B) and seat them on the A-pillar trim (C) as shown.
11. Reinstall the A-pillar trim (A).
1. Insert the bottom of the trim into the dashboard (B).
2. Place the trim over the A-pillar (C), and fit its upper clip (D) and the other clips (E) into holes (F) in the A-pillar, then lightly push the trim into
place.
NOTE:
-
Make sure the side curtain airbag isn't tucked down under the clips and ribs.-
-
Push lightly on the upper clip. If you push too hard, the clip will be damaged, and it will not hold the trim properly.
12. Reinstall the front door opening seal.
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
B-Pillar Upper/Lower Trim
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
