RDX L4-2.3L Turbo (2008)
Air Bag: Removal and Replacement
Side Airbag Replacement
Side Airbag Replacement
NOTE:
-
Review the seat replacement procedure before doing repairs or service.
-
If the side airbag deployed, replace the seat frame.
Removal
1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Disconnect the side airbag harness 2P connector (A).
3. Remove the seat assembly and seat-back cover.
4. Remove the TORX bolts (A) and mounting nut (B), then remove the side airbag (C) and side airbag bracket (D).
Installation
NOTE:
-
If the side airbag lid is secured by tape, remove the tape.
-
Do not open the lid of the side airbag cover.
-
Use new mounting bolts tightened to the specified torque. When you replace a side airbag, make sure that the seat-back cover is installed properly.
Improper installation may prevent proper deployment.
-
Be sure to install the harness wires so that they are not pinched or interfering with other parts.
1. Place the new side airbag and the side airbag module bracket on the seat-back frame (A). Tighten the side airbag mounting nut (B) and TORX bolt
(C).
