RDX L4-2.3L Turbo (2008)
Seat Belt: Service and Repair
Front Seat Belt Replacement
Front Seat Belt Replacement
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE: Check the front seat belts for damage, and replace them if necessary.
Front Seat Belt
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Slide the front seat forward fully, then move to lowest position (driver's seat). Remove the anchor cover (A).
3. Slide the front seat forward fully, then move it to the lowest position (driver's seat).
Driver's seat: Carefully push in on the bottom edge of the anchor cover (A) to replace the lock tab (B) then side the cover up to replace the hooks
(C), and remove the cover.
Passenger's seat: Carefully pry up on the bottom edge of the anchor cover (D) to release the hooks (E), and remove the cover.
4. Remove the lower anchor bolt (A).
5. Remove the B-pillar lower trim.
6. Remove the B-pillar upper trim and slider.
7. Remove the upper anchor bolt (A).
