RDX L4-2.3L Turbo (2008)
Seat Belt: Service and Repair
Rear Seat Belt Replacement
Rear Seat Belt Replacement
NOTE: Check the second row seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.
Rear Seat Belt
1. Pull on the front of the seat cushion, then tilt the seat cushion forward.
2. Remove the rear door sill trim.
3. Pull the carpet back, and remove the lower anchor bolt (A).
4. Remove these items:
-
Rear seat-back, fold down
-
Rear seat side bolsters, both sides
-
Cargo area side trim panel, both sides
5. Remove the front retractor bolt (A) and rear retractor bolt (B), then remove the rear seat belt (C) and retractor (D).
6. Install the rear seat belt and retractor in the reverse order of removal, and note these items:
-
Apply medium strength type liquid thread lock to the anchor bolts before reinstallation.
-
Check that the retractor locking mechanism functions as described.
-
Before installing the anchor bolt, make sure there are no twists or kinks in the rear seat belt.
Center Seat Belt and Seat Belt Buckle
1. Pull up on the front of the rear seat cushion, then tilt the rear seat cushion forward. Pull back the carpet as needed.
2. Remove the center anchor bolts (A), then remove the right seat belt buckle (B), center seat belt buckle (C), and left seat belt buckle (D).
