RDX L4-2.3L Turbo (2008)
7. Measure distance (1) between the end of the rear differential side case (A) and 60.2 mm shim contact area of planetary gear (B) with a straight
edge (C) and depth gauge (D).
Measure at three locations, and average the reading.
NOTE:
^
Carry out the measurement at normal room temperature.
^
Clean all the parts thoroughly before measure.
8. Measure distance (2) between the end of the rear differential center case (A) and ring gear contact area of tapper roller bearing (B) with a straight
edge (C) and depth gauge (D).
Measure at three locations, and average the reading.
NOTE:
^
Carry out the measurement at normal room temperature.
^
Clean all the parts thoroughly before measure.
9. Measure the distance (3) between the needle bearing (A) and tapper roller bearing contact area of ring gear (B) with a depth gauge (C).
Measure at three locations, and average the reading.
NOTE:
^
Carry out the measurement at normal room temperature.
^
Clean all the parts thoroughly before measure.
