RDX AWD L4-2.3L Turbo (2010)
-
Make sure the side curtain airbag is not tucked under the clips and ribs.
-
Do not push too hard on the A-pillar trim. If you push too hard, the clip will be damaged, and it will not hold the trim properly.
12. Reinstall the front door opening seal.
B-Pillar Upper/Lower Trim
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
If side airbags and/or side curtain airbags have deployed, the affected pillar area trim and attachment clips must be replaced. Refer to Component
Replacement/Inspection After Deployment See: Restraint Systems/Air Bag Systems/Service and Repair.
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to bend or scratch the trim or the panels.
1. Remove these items:
-
Front door sill trim See: Scuff Plate/Service and Repair
-
Rear door sill trim See: Scuff Plate/Service and Repair
-
Front door opening seal, as needed See: Scuff Plate/Service and Repair
-
Rear door opening seal, as needed See: Scuff Plate/Service and Repair
-
Front seat belt lower anchor bolt See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Belt Replacement
2. Slide the front seat forward fully.
3. Remove the B-pillar lower trim (A).
1. Pull the upper portion of the trim back to detach the upper hooks (B).
2. Detach the lower clips by pulling the bottom of the trim back by hand.