RDX AWD L4-2.3L Turbo (2010)
7. Remove the upper and lower pad retainers (A).
NOTE: The upper and lower pad retainers are different. During installation, make sure the pad retainers are in the proper positions.
8. Clean the caliper bracket (B) thoroughly; remove any rust, and check for grooves and cracks. Verify that the caliper pins (C) move in and out
smoothly. Clean and lube if needed.
9. Inspect the brake disc/drum for runout, thickness, parallelism See: Brake Rotor/Disc/Testing and Inspection/Rear Brake Disc Inspection, and
check for damage and cracks.
10. Apply a thin coat of M-77 assembly paste (P/N 08798-9010) to the retainer mating surface of the caliper bracket (indicated by the arrows).
11. Install the upper and lower pad retainers. Wipe excess assembly paste off the retainers. Keep the assembly paste away from the brake discs and
brake pads.
12. Install the brake caliper piston compressor tool (A) on the caliper body (B).
