RDX AWD L4-2.3L Turbo (2010)
13. Press in the piston with the brake caliper piston compressor tool so the caliper will fit over the brake pads. Make sure the piston boot is in position
to prevent damaging it when pivoting the caliper down.
NOTE: Be careful when pressing in the piston; brake fluid might overflow from the master cylinder's reservoir. If brake fluid gets on any painted surface,
wash it off immediately with water.
14. Remove the brake caliper piston compressor tool.
15. Apply a thin coat of M-77 assembly paste (P/N 08798-9010) to the pad side of the shim (A), the back of the brake pads (B), and the other areas
indicated by the arrows. Wipe excess assembly paste off the pad shim and brake pads friction material. Keep grease and assembly paste away from
the brake disc/drum and brake pads. Contaminated brake disc/drum or brake pads reduce stopping ability.