RDX AWD L4-2.3L Turbo (2010)
13. Remove the old liquid gasket from the lower block mating surfaces, bolts, and bolt holes.
14. Clean and dry the lower block mating surfaces.
15. Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the engine block mating surface of the lower block and to the
inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
-
Apply a 3 mm (0.12 in) diameter bead of liquid gasket along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
16. Put the lower block on the engine block.
17. Apply new engine oil to the threads and flange of the bearing cap bolts.
18. Torque the bearing cap bolts, in sequence, to 29 Nm (3.0 kg-m, 22 lb-ft).