RDX AWD L4-2.3L Turbo (2010)
5. Pull the seat belt buckle switch harness (D) out through the space between the seat cushion and the seat track (driver's seat), or through the hole in
the seat track (passenger's seat).
6. Install the buckle in the reverse order of removal, and note these items:
-
Assemble the washers, collar on the center anchor bolt as shown.
-
Apply medium strength liquid thread lock to the center anchor bolt before reinstallation.
-
Tighten the bolts by hand first, then tighten to specification with a torque wrench.
-
Make sure the seat belt buckle switch connector and seat belt buckle tensioner connector are plugged in properly.
-
Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
-
Check for any DTCs that may have been set during repairs, and clear them.