RDX AWD L4-2.3L Turbo (2010)
4. Slowly raise the floor jack until you align the bolt hole with the holes in lower arm B and the knuckle, then loosely install the new flange bolt (A).
5. Compress the damper by hand until you align the bolt hole with the holes in lower arm B and the damper, then loosely install the new flange bolt
(C).
6. Connect the stabilizer link to lower arm B See: Stabilizer Bar/Stabilizer Link/Service and Repair/Rear Stabilizer Link Removal/Installation.
7. Raise the rear suspension with the floor jack until the vehicle just lifts off the lift, then tighten the flange bolts and the self-locking nut to the
specified torque.
8. Clean the mating surface of the brake disc/drum and the inside of the wheel, then install the rear wheel.
9. Check the rear wheel alignment, and adjust it if necessary See: Alignment/Service and Repair.