RDX AWD L4-2.3L Turbo (2010)
12. Remove the shift lock solenoid plunger (D), plunger spring (E), and shift lock stop and shift lock stop cushion (F).
13. Replace the shift lever/shift cable bracket assembly.
14. Install the shift lock stop and shift lock stop cushion.
15. Apply silicone grease to joint of the shift lock solenoid plunger and shift lock stop, if necessary. Keep the connector terminals free of silicone
grease.
16. Install the shift lock solenoid plunger and plunger spring in the shift lock solenoid.
17. Install the shift lock solenoid by aligning the joint of the shift lock solenoid plunger with the tip of the shift lock stop, then push the shift lock
solenoid into the shift lever securely.
18. Install the park pin switch, and secure the switch with a new screw.
19. Install the shift lock solenoid connector and park pin switch/A/T gear position indicator panel light connector.
20. Route the park pin switch harness and indicator panel light harness, and secure the harnesses with the harness wire tie (A); tie the indicator panel
light harness at the white tape (B) with the harness wire tie.