RDX AWD L4-2.3L Turbo (2010)
2. Make marks (A) on each roller (B) and the inboard joint (C) to identify the locations of rollers to the grooves in the inboard joint.
NOTE: Do not engrave or scribe any marks on the rolling surface.
3. Remove the inboard joint on a clean shop towel (D). Be careful not to drop the rollers when separating them from the inboard joint.
4. Make marks (A) on the spider (B) that match the marks on the rollers, then remove the rollers.
NOTE: Do not engrave or scribe any marks on the rolling surface.
5. Remove the circlip (C).
