RDX AWD L4-2.3L Turbo (2010)
6. Make marks (D) on the spider and the driveshaft (E) to identify the position of the spider on the shaft.
7. Remove the spider.
NOTE: If necessary, use a commercially available bearing puller while being careful not to damage the spider.
8. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damaging the boot.
9. Remove the inboard boot. Be careful not to damage the boot.
10. Remove the vinyl tape.
Outboard Joint Side
1. Remove the boot bands (A). Lift up the three tabs (B) using a screwdriver, then release the band. Be careful not to damage the boot.
2. Slide the outboard boot (A) partially toward the inboard joint side. Be careful not to damage the boot.