RDX AWD L4-2.3L Turbo (2010)
2. Install the inboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to damage the inboard boot.
3. Assemble the steel balls (A), the bearing retainer (B), and the bearing race (C) by aligning the marks (D) you made on the bearing retainer and the
bearing race.
4. Install the bearing onto the driveshaft (E) by aligning the marks you made on the bearing and the driveshaft. Be careful not to drop the steel balls
when installing the bearing onto the driveshaft.
5. Install the snap ring (F).
6. Pack the inboard joint with the joint grease included in the new inboard boot set.