RL V6-3.5L (2007)
B-Pillar Upper Trim
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove these items:
-
Front door opening trim, as needed
-
Rear door opening trim, as needed
2. Remove the front seat belt lower anchor.
3. Pull the upper portion of the B-pillar lower trim (A) back to release the upper hooks (B).
4. Remove the B-pillar upper trim (A).
1. Pull the bottom of the trim back by hand to detach the lower hooks (B).
2. Detach the upper clip by pulling the top of the trim.
3. Pull the trim down to release the upper hook (C) from the side curtain airbag B-pillar bracket.
4. Pass the front seat belt (D) lower anchor out through a hole in the slider (E).
