RL V6-3.5L (2007)
5. Drying of overcoat clear coat. After painting the overcoat clear coat, take about 10 to 20 minutes setting time, and force dry it. Force dry the
surface for about 40 to 60 minutes at a temperature or 154 degree F (70 degree C).
6. Polishing.
Take out small cavities (A) or paint grains (B).
-
Remove the small cavities and paint grains with a honing stone (C).
-
First flatten the honing surface and round the edges (D).
-
Hone the surface with a rough stone and finish with a fine P1200 to P2000 stone.
-
If the paint flow or grains is high, scrape it out with a knife first before honing it.
7. Finishing of painted surface.
Using waterproof P1200 to P2000 sandpaper (A) the surface together with soap and water or water in fixed direction. After the surface becomes
flat and smooth.Wipe off the remaining particles.
NOTE: Be careful not to polish too much to remove the overcoat clear coat.
8. Final polishing.
-
With fine compound, polish the surface with a polisher (A) set with a towel buff (B) or intermediate sponge buff to take off honing or
sandpaper marks. And finally, polish it out with finer compound.
-
In polishing, remove honing powders frequently to avoid damaging the paint surface.
NOTE: Turn on the polisher power switch after it has been in touch with the polished surface
9. Glossing.
-
Using slender buff with ultra fine compound, polish the painted surface.
-
Press the polisher very lightly on the surface to be polished.
