RL V6-3.5L (2007)
38. Install the rocker arm oil control solenoid/oil filter assembly (A), with a new rocker arm oil control solenoid filter (B).
39. Install the oil pan.
40. Install the crankshaft position (CKP) sensor.
41. Install the cylinder heads.
42. Install the drive plate.
43. Install the transmission.
44. Install the engine assembly.
NOTE: When any crankshaft or connecting rod bearing is replaced, after assembly it is necessary to run the engine at idling speed until it reaches
normal operating temperature, then continue to run it for about 15 minutes.
