RL V6-3.5L (2007)
18. Rotate the overrunning clutch (A) in both directions. It should lock and move upward in one direction and rotate smoothly in the other direction. If
it does not lock in either direction or if it locks both directions, then replace it.
19. If the starter drive gear (B) is worn or damaged, replace the overrunning clutch assembly; the gear is not available separately. Check the condition
of the idler gear and drive plate ring gear to see if the starter drive gear teeth are damaged.
Starter Reassembly
20. Install the armature into the housing.
21. Place the brush holder assembly on the armature, then move the brush holder (A) down to the armature.
22. Install the end cover to retain the brush holder.
