RL V6-3.5L (2007)
4. Place a floor jack at the connecting point of lower arm B and the stabilizer link.
5. Remove the cotter pin (A) from the lower arm B ball joint, and loosen the nut (C).
NOTE: During installation, insert the new cotter pin into the ball joint pin hole from the rear to the front of vehicle, and bend its end as shown.
6. Disconnect the lower arm ball joint from the knuckle using the ball joint remover.
7. Lower the floor jack gradually.
8. Remove the spring (A), spring mounting cushion (B), and lower spring seat (C).
Installation
1. Install the spring mounting cushion (A) and spring (B).