RL V6-3.7L (2009)
10. Remove the screws (A, B), then separate the door grip (C), the armrest (D), the power window switch panel (E), the grip bracket (F), the pull
pocket (G), and the power window switch (H).
11. Install the door panel in the reverse order of removal, and note these items:
-
Replace any damaged cable fasteners with new ones.
-
Before reinstalling the door panel, install the clips.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
If you replace the latch cable (A), attach the cable to the cable fastener (B) with the latch in lock position as shown.
-
Make sure the connector is plugged in properly, and the cable is connected properly.
-
Make sure the window and power door lock operate properly.
