RL V6-3.7L (2009)
Trim Panel: Service and Repair
Interior Trim Removal/Installation - C-Pillar Trim
Interior Trim Removal/Installation - C-Pillar Trim
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
C-Pillar Trim
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
Follow the C-pillar trim installation procedure carefully; improper installation could cause the side curtain airbags to deploy improperly, and
possibly cause injury.
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
The upper clip in the C-pillar trim (A) consists of a plastic grommet (B) and a metal pin (C). The groove (D) in the grommet secures it to the body
panel (E). The shoulder (F) on the grommet is broken during removal, so the grommet must be replaced with a new one when the trim is
reinstalled.
1. Remove these items:
-
Rear seat cushion See: Seats/Service and Repair/Rear Seat Removal/Installation
-
Rear seat-back See: Seats/Service and Repair/Rear Seat Removal/Installation
-
Rear door sill trim See: Scuff Plate/Service and Repair/Interior Trim Removal/Installation - Rear Door Sill Area
-
Rear door opening trim, as needed See: Scuff Plate/Service and Repair/Interior Trim Removal/Installation - Rear Door Sill Area
2. Release the upper hook (A) from the C-pillar trim (B), then detach the clips by pulling the seat side trim (C) back, then remove it.