RL V6-3.7L (2009)
-
When installing the front up-down motor (A), adjust the gear (B) to the motor pinion (C) by slightly rotating the brake (D) with a 8 mm
hexagonal wrench.
-
Make sure the motor connector is plugged in properly.
-
Check the front seat up-down operation.
Rear Up-down Motor - 8-Way Power Seat
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs
or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to tear the seam or damage the seat covers.
Removal
1. Remove the front seat. See: Service and Repair/Front Seat Removal/Installation
2. Remove these items:
-
Seat-back cover/pad See: Seat Cover/Service and Repair/Front Seat-back Cover Replacement
-
Seat cushion cover/pad See: Seat Cover/Service and Repair/Front Seat Cushion Cover Replacement
3. Remove the rear brake (A) and the rear brake bracket (B) as an assembly.
-1 Using a TORX T30 bit, remove the brake bracket mounting bolts (C).
-2 Using a TORX T40 bit, remove the brake bracket mounting bolt (D).
-3 Pull the brake bracket back to remove the gear (E) from the brake gear axle.
4. Remove the gear (A).