RL V6-3.7L (2009)
5. Manually lower the seat frame down fully to access the rear bolt securing the rear up-down motor.
6. Disconnect and detach the motor connector (A). Using a TORX T30 bit, remove the bolts, then remove the rear up-down motor (B).
7. Apply multipurpose grease to the pivot portions of the up-down adjuster.
Installation
8. Using a TORX T30 bit, remove the bolts, then remove the rear brake (A) from the rear brake bracket (B).
9. Apply multipurpose grease to the motor pinion.
10. Install the rear up-down motor (A). Using a TORX T30 bit, fasten the bolts. Connect the motor connector (B) and fasten the connector clip (C) to
the seat frame. Make sure the connector is plugged in properly.
11. Manually raise the seat frame fully upward.