RL V6-3.7L (2009)
Is there a change in voltage (12 V to 0 V or 0 V to 12 V)?
YES - Inspect the ground for the component. If OK, replace the component.
NO - Replace the control unit that controls the malfunctioning component.
9. Select DATA LIST from the TEST MODE MENU, and make sure the switch signal input for the malfunctioning system indicates a change when
operated.
Does the switch input indicated ON when the switch is ON?
YES - Replace the control unit that controls the malfunctioning component.
NO - Go to step 10.
10. Check the switch and its ground (if applicable), then check for an open or a short in the wire between the switch and the control unit that monitors
it.
Is the switch and the wire harness OK?
YES - Replace the control unit that monitors the switch.
NO - Replace the switch or repair the wire harness.