RL V6-3.7L (2009)
Installation
1. Place the new front passenger's airbag (A) into the bracket. Torque the front passenger's airbag mounting nuts (B).
2. Connect the front passenger's airbag 4P connector (A) to dashboard wire harness A, then reinstall the glove box.
3. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
4. Connect the HDS and clear the DTCs.
5. After installing the airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6
seconds and then go off.
Installation of the front passenger's airbag after a collision where it deployed
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures then wait at least 3 minutes
before starting work.
2. Remove the dashboard assembly from the vehicle. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Dashboard Replacement
3. Place the new front passenger's airbag (A) into the bracket. Torque the front passenger's airbag mounting nuts (B).
NOTE:
-
Be sure to install the front passenger's airbag so it does not interfere with other parts.
-
When you install the front passenger's airbag, be careful not to damage the bag.
-
Be sure to keep the new airbag clean and do not unfold or tamper with the cloth cover on the airbag.
4. Install the dashboard assembly into the vehicle. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Dashboard Replacement
