RSX L4-2.0L (2005)
8. Remove the side airbag , and release the hooks (A) from the airbag module holder (B).
9. Pull back the edge of the seat-back cover (A) all the way around, and release the clips (B), then remove the seat-back cover.
10. Install the cover in the reverse order of removal, and note these items:
-
To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the hooks,
fasteners (05-06 models), and clips.
-
Make sure the side airbag harness and OPDS harness (passenger's seat) are routed properly.
-
Replace any clips you removed with new ones. Install them with commercially available upholstery ring pliers.
-
If necessary, reinitialize the OPDS control unit.
-
Always use the proper replacement cover; never install an aftermarket cover.
Seat Cushion Cover
1. Remove the front seat