RSX L4-2.0L (2005)
3. Apply liquid gasket, P/N 08718-0001 or 08718-0009, evenly to the engine block mating surface of the oil pan and to the inner threads of the bolt
holes.
NOTE: Do not install the parts if 4 minutes or more have elapsed since applying liquid gasket. Instead, reapply liquid gasket after removing the
old residue.
4. Install the oil pan.
5. Tighten the bolts in two or three steps. In the final step, tighten all bolts in sequence to 12 Nm (1.2 kgf-cm, 8.7 ft. lbs.). Wipe off the excess liquid
gasket on the each side of crankshaft pulley and flywheel/drive plate.
NOTE:
^
Wait at least 30 minutes before filling the engine with oil.
^
Do not run the engine for at least 3 hours after installing the oil pan.
6. Install the clutch cover (A), and tighten the two bolts (B) securing the transmission.
7. If the engine is still in the vehicle, install the subframe.