RSX L4-2.0L (2005)
15. Insert the brush (A) into the brush holder, and bring the brush into contact with the commutator, then attach a spring scale (B) to the spring (C).
Measure the spring tension at the moment the spring lifts off the brush. If the spring tension is not within specification, replace the spring.
Planetary Gear Inspection
16. Check the planetary gears (A) and ring gear (B). Replace them if they are worn or damaged.
Overrunning Clutch Inspection (K20A3 Engine)
17. Holding the drive gear (A), turn the gear shaft (B) clockwise. Check that the drive gear comes out to the other end. If the drive gear does not move
smoothly, replace the gear cover assembly.
18. Holding the drive gear, turn the gear shaft counterclockwise. The gear shaft should rotate freely. If the gear shaft does not rotate smoothly, replace
the gear cover assembly.
19. If the starter drive gear is worn or damaged, replace the overrunning clutch assembly; the gear is not available separately. Check the condition of
the flywheel or torque converter ring gear. Replace it if the starter drive gear teeth are damaged.
Overrunning Clutch Inspection (K20A2, K20Z1 Engines)
20. Slide the overrunning clutch along the shaft. Replace it if it does not slide smoothly.
