RSX L4-2.0L (2005)
21. Rotate the overrunning clutch (A) both ways.
Does it lock in one direction and rotate smoothly in reverse? If it does not lock in either direction or it locks in both directions, replace it.
22. If the starter drive gear (B) is worn or damaged, replace the overrunning clutch assembly; the gear is not available separately.
Check the condition of the flywheel ring gear. Replace it if the starter drive gear teeth are damaged.
Starter Reassembly (K20A3 Engine)
23. Install the brush into the brush holder, and set the armature (A) in the brush holder (B).
NOTE: To seat the new brushes, slip a strip of #500 or #600 sandpaper, with the grit side up, between the commutator and each brush, and
smoothly rotate the armature. The contact surface of the brushes will be sanded to the same contour as the commutator.
24. Squeezing a spring (C), insert it in the hole on the brush holder, and push it until it bottoms. Repeat this for the other three springs (D, E, and F).
25. Install the armature and brush holder assembly into the housing.
NOTE: Make sure the armature stays in the holder.
Starter Reassembly (K20A2, K20Z1 Engines)
26. Pry back each brush spring with a screwdriver, then position the brush about halfway out of its holder, and release the spring to hold it there.
NOTE: To seat the new brushes, slip a strip of #500 or # 600 sandpaper, with the grit side up, between the commutator and each brush, and
