RSX L4-2.0L (2005)
Rear Knuckle Alignment Link: Service and Repair
Knuckle Replacement
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. Remove the rear wheels.
2. Remove the brake disc and hub bearing unit.
3. Remove the flange bolts (A) and splash guard (B) from the knuckle.
4. Remove the wheel sensor (A), brake hose mounting bracket (B), and parking cable mounting bracket (C) from the knuckle. Do not disconnect the
wheel sensor connector.
5. Place the floor jack under the trailing arm (A) to support it.
NOTICE: Do not place the jack against the plate section of the lower arm. Be careful not to damage any suspension components.
6. Remove the flange bolt (B), then disconnect the upper arm (C) from the knuckle.