RSX L4-2.0L (2005)
4. Install a new self-locking nut (A) on the damper shaft.
5. Hold the damper shaft with a hex wrench (B), and tighten the self-locking nut to the specified torque.
Installation
1. Lower the lower arm, and position the damper assembly in the body. Turn the damper mounting base so that the [triangle L] mark (A) faces
toward the outside of the vehicle.
2. Loosely install the flange nuts (B) onto the top of the damper.
3. Position the damper bottom on the knuckle, and install the new damper pinch bolts (A) and nuts (B), and lightly tighten the nuts.
4. Place the floor jack under the lower arm ball joint, and raise the suspension to load it with the vehicle's weight.
NOTICE: Do not place the jack against the flat section of the lower arm. Lifting the arm in this area might bend it.
5. Tighten the flange nuts on the top of the damper to the specified torque value.
6. Tighten the damper pinch nuts to the specified torque value.
