RSX L4-2.0L (2005)
5. When reassembling the valve body, align the hole in the regulator spring cap with the hole in the valve body, then press the spring cap into the
valve body, and tighten the stop bolt.
Servo Body Disassembly, Inspection, and Reassembly
1. Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air. Blow out all passages.
2. Inspect the valve body for scoring and damage.
3. Check shift valve D for free movement. If any fail to slice freely, refer to valve body repair.
4. Do not hold the shift solenoid valve connector to remove and install it. Be sure to hold the shift solenoid valve body. When installing the shift
solenoid valves, refer to Shift Solenoid Valves Installation.
5. Coat all parts with ATF during assembly.