RSX L4-2.0L (2005)
6. Replace the O-rings with new ones.
Shift Solenoid Valve Installation
NOTE:
-
Do not install the shift solenoid valve A and B before installing the shift solenoid valve D and E. If solenoid valve A and B are installed, before
solenoid valves D and E, it may damage the hydraulic control system.
-
Do not hold the shift solenoid valve connector to install it. Hold the shift solenoid valve body.
1. Install the new O-rings (F) on each shift solenoid valves.
NOTE: The new shift solenoid valve is equipped with new O-ring. If you install a new shift solenoid valve. there is no need to replace its O-rings.
2. Install shift solenoid valve D by holding the shift solenoid valve body; be sure the mounting bracket contacts the servo body.