TL L5-2451cc 2.5L SOHC MFI (1997)
11. Install the ATF strainer with a new O-ring (four bolts).
TORQUE: 12 Nm (8.7 ft. lbs.).
12. Install the ATF pan with two dowel pins and a new ATF pan gasket (fifteen bolts) as shown. Make sure that the shift control solenoid valve
harness is not pinched by the ATF pan.
TORQUE: 12 Nm (8.7 ft. lbs.).
13. Install the AT gear position switch cover. Tighten the bolt on the ATF pan side loosely so that there is no clearance between the A/T gear position
switch cover and the ATF pan. Then tighten the bolt on the rear cover side to the specified torque, and tighten the bolt on the ATF pan side to the
specified torque.
TORQUE: 12 Nm (8.7 ft.lbs.).
14. Connect the shift control solenoid valve connector.