TL V6-3.2L (2004)
Trim Panel: Service and Repair
Trim Removal/Installation - Pillar Areas
Trim Removal/Installation - Pillar Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
A-pillar
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Pull out the front door opening trim as needed.
2. Remove the A-pillar trim (A).
1. Pry up on the A-pillar cap (B), release the hooks (C), and pull the cap out so that the tapered pin on the cap releases the grommet (D).
2. Pull the A-pillar trim back by hand to detach the clip, then pull the trim up.
3. Install the trim in the reverse order of removal, and note these items:
-
Check for damaged or stress-whitened clips, and replace them with new ones.
-
Do not reuse the A-pillar cap; always replace it.
-
If the side curtain airbag has deployed, replace the A-pillar trim with new one.
-
To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect removed pieces and replace them if they
have any of these types of damage:
-
Any cracks, deformations, or press-whitenings in the A-pillar trim (A)
