TL V6-3.2L (2004)
Camshaft: Service and Repair
Camshaft, Rocker Arm, Seal, Pulley
Camshaft, Rocker Arm, Camshaft Seal, and Pulley Installation
1. Apply a light coat of new engine oil around the camshaft oil seal.
2. Gently tap the new camshaft oil seal (A) into the cylinder head.
3. Insert the camshaft (B) into the cylinder head, then install the camshaft thrust cover (C). Always use a new O-ring (D). Apply new engine oil to the
camshaft journals and lobes.
4. Check that the oil seal lips are not distorted.
5. Install the solid dowel pins (E) and the hollow dowel pins (F).
6. Loosen the valve adjusting screws.
7. Set the rocker arm assembly in place, and loosely install the bolts. Make sure that the rocker arms are properly positioned on the valve stems.
8. Tighten each bolt two turns at a time in the sequence shown to ensure that the rockers do not bind on the valves.
NOTE: Apply new engine oil to the threads and flange of the exhaust rocker shaft mounting bolts.
