TL V6-3.2L (2004)
Air Door Actuator / Motor: Service and Repair
Recirculation Control Motor
Recirculation Control Motor Replacement
1. Turn the ignition switch OFF.
2. Remove the glove box housing.
3. Remove the throttle actuator control module.
4. Disconnect the 5P connector (A) from the recirculation control motor (B). Remove the self-tapping screws and the recirculation control motor
from the blower unit.
5. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make
sure the motor runs smoothly.