TL V6-3.2L (2004)
-
Apply liquid thread lock to the anchor bolts before reinstallation.
-
Tighten the bolts by hand first, then tighten to specification with a torque wrench.
-
Check that the retractor locking mechanism functions as described.
-
Assemble the washers, collar and bushing on the upper and lower anchor bolts as shown.
-
If the seat belt tensioner has been activated, replace the front seat belt protector with a new one.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
-
Make sure the seat belt tensioner and tension reducer connectors are plugged in properly.
-
Reconnect the negative cable to the battery.
-
Check for any DTCs, and clear them using the HDS. If the DTCs will not clear, perform the necessary troubleshooting.
-
Enter the antitheft codes for the audio and navigation systems, then enter the customer's XM radio channel presets.
-
Set the clock (without navigation system).
Seat Belt Buckle
1. Make sure you have the anti-theft codes for the audio and navigation Systems, and then write down the XM radio channel presets.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove the front seat.
4. Remove the center cover, 4-way power seat, 10-way power seat.
5. Disconnect or detach the seat belt switch connector (A).