TL V6-3.5L (2007)
Brake Caliper: Overhaul
Front
Front Brake Caliper Overhaul
CAUTION
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^
Avoid breathing dust particles.
^
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Except Type S Model
Remove, disassemble, inspect, reassemble, and install the caliper, and note these items:
NOTE: Make sure that the caliper pins are installed correctly. Upper caliper pin B and lower caliper pin A are different. If the these caliper pins are
installed in the wrong location, it will cause vibration, uneven or rapid pad wear, and possibly uneven tire wear.
^
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
^
To prevent dripping brake fluid, cover disconnected hose joints with rags or shop towels.
^
Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
^
Before reassembling, check that all parts are free of dirt and other foreign particles.
^
Replace parts with new ones as specified in the illustration.,
^
Make sure no dirt or other foreign matter gets in the brake fluid.
^
Make sure no grease or oil gets on the brake discs or pads.
^
When reusing brake pads, always reinstall them in their original positions to prevent loss of braking efficiency.
^
Do not reuse drained brake fluid. Use only clean Acura DOT 3 brake fluid from an unopened container. Using a nonAcura brake fluid can cause
corrosion and shorten the life of the system.
^
Do not mix different brands of brake fluid as they may not be compatible.
^
Coat the piston, piston seal groove, and caliper bore with clean brake fluid.
^
Replace all rubber parts with new ones whenever disassembled.
^
After installing the caliper, check the brake hose and line for leaks, interference, and twisting.
CAUTION
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^
Avoid breathing dust particles.
^
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Type S Model (4-piston Caliper Type)
Remove, disassemble, inspect, reassemble, and install the caliper, and note these items:
NOTE: Do not disassemble these calipers, they can not be rebuilt.
^
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
^
To prevent dripping brake fluid, cover disconnected hose joints with rags or shop towels.
