TL V6-3.5L (2007)
2. Install the brake hose (A) on the upper brake hose bracket (B) with a new brake hose clip (C).
3. Connect the brake line (D) to the brake hose.
4. After installing the brake hose, bleed the brake system.
5. Do the following checks:
^
Check the brake hose and line joint for leaks, and tighten if necessary.
^
Check the brake hoses for interference and twisting.
Installation - Front - Type S Model
1. Replace the brake hose (A) if the hose is twisted, cracked, or leaking.
2. Disconnect the brake hose from the brake line (B) using a 10 mm flare-nut wrench (C).
3. Remove and discard the brake hose clip (A) from the brake hose (B).
4. Remove the brake hose from the brake hose brackets (C).
Installation - Front - Type S Model
1. Insert the brake hose (A) through the brake hose brackets (B).