TL V6-3.5L (2007)
6. Release the hook (A) of the seat cushion cover on passenger's 4-way power seat. Remove the center anchor bolt (B), and detach the harness clip
(C) on the driver's and passenger's seats, then remove the seat belt buckle (D).
7. Pull the seat belt buckle switch harness (E) out through the space between the seat cushion and the seat linkage or through the hole in the seat
track.
8. Install the buckle in the reverse order of removal, and note these items:
-
Assemble the washers on the center anchor bolt as shown.
-
Apply liquid thread lock to the center anchor bolt before reinstallation.
-
Tighten the bolts by hand first, then tighten to specification with a torque wrench.
-
Make sure the seat belt buckle switch connector is plugged in properly.
-
Reconnect the negative cable to the battery.
-
Enter the anti-theft codes for the audio and the navigation system (if equipped), then enter the audio presets.
-
Set the clock (without navigation system).
Passenger's Seat Belt Lower Anchor
1. Make sure you have the anti-theft codes for the audio and the navigation system (if equipped), then write down the audio presets.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove the front seat.
4. Remove the recline cover.
5. Remove the lower anchor bolt (A), then remove the lower anchor (B).
