TL V6-3.5L (2007)
^
To avoid damaging the ball joint, install the ball joint thread protector onto the threads of the ball joint.
^
Be careful not to damage the ball joint boot when installing the remover.
^
Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
10. Pull the knuckle outward, and separate the outboard joint from the front wheel hub using a plastic hammer.
11. Right driveshaft: Drive the inboard joint (A) off of the intermediate shaft using a drift and a hammer. Remove the driveshaft as an assembly.
NOTE: Do not pull on the driveshaft (B) or the inboard joint may come apart.
12. Left driveshaft: Pry the inboard joint (A) from the transmission housing with a prybar. Remove the driveshaft as an assembly.
NOTE: Do not pull on the driveshaft (B) or the inboard joint may come apart. Pull the driveshaft straight out to avoid damaging the oil seal.
