TL V6-3.5L (2007)
Axle Shaft Assembly: Removal and Replacement
Dynamic Damper Replacement
Dynamic Damper Replacement
1. Remove the inboard joint.
2. Remove the dynamic damper band.
^
If the band is a welded type, cut the band.
^
If the band is a double loop type, lift up the band end, then push it into the clip.
^
If the band is a low profile type, pinch the band using commercially available boot band pliers.
3. Remove the dynamic damper.
4. Install the new dynamic damper, and adjust to these measurements.
NOTE: Be careful not to swap the dynamic dampers. The right and the left dynamic dampers are different.
5. Install the dynamic damper band.
6. Install the inboard joint.