TL AWD V6-3.7L (2010)
17. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
18. Install the glass and the regulator in the reverse order of removal, and note these items:
-
If the clip is damaged or stress-whitened, replace it with a new one.
-
Push the hooks into place securely.
-
Make sure the connectors are plugged in properly.
-
Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
-
Roll the glass up and down to make sure it moves freely without binding.
-
Adjust the position of the glass as necessary See: Front Door/Front Door Window Glass/Adjustments.
-
Make sure the power door locks and the power windows operate properly.
-
Make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal out water.
-
Check for water leaks See: Front Door/Front Door Window Glass/Adjustments.
-
Test-drive the vehicle, and check for wind noise and rattles.